Removal and replacement procedures 36
4.
Remove the drive.
To replace the component, reverse the removal procedure.
Power supply blank
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless
all bays are populated with either a component or a blank.
To remove the component:
1. Access the rear panel ("Access the product rear panel" on page 33).
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power supply or
power supply blank to cool before touching it.
2. Remove the power supply blank.
To replace the component, reverse the removal procedure.
Power supply
To remove the component:
1. Power down the server (on page 31).
2. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
