Removal and replacement procedures 49
7.
Remove the fan board.
To replace the component, reverse the removal procedure.
DIMMs
To remove the component:
1. Power down the server (on page 31).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
o Extend the server from the rack (on page 32).
o Remove the server from the rack (on page 34).
4. Remove the access panel ("Access panel" on page 37).
5. Remove the air baffle ("Air baffle" on page 42).
6. Open the DIMM slot latches.
To Next Page
Loading...
