Before installing the controller, you must observe the following requirements:
• To ensure that cables are connected correctly, observe the labels on the cable and component connectors.
• Be sure that you have the latest firmware for the controllers, HBAs, and the expander card. To download
the latest firmware, see the Hewlett Packard Enterprise website.
Prerequisites
Before installing this option, be sure that you have the following:
• The components included with the hardware option kit
Procedure
1. Power down the server (Power down the server on page 38).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 38).
• Remove the server from the rack (Removing the server from the rack on page 39).
4. Remove the access panel (Removing the access panel on page 40).
5. Remove the PCIe riser cage (Removing the PCIe riser cages on page 44).
6. Install the controller.
7. Install the primary PCIe riser cage (Installing the primary PCIe riser cage on page 45).
8. Connect the appropriate SAS cables. For more information, see "Cabling on page 109."
9. Install the access panel (Installing the access panel on page 41).
10. Install the server into the rack (Installing the server into the rack on page 34).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Before powering on the system, be sure that the HPE Smart Storage Battery is installed. See "
Installing
a Smart Storage Battery on page 103."
14. Power up the server (Powering up the server on page 38).
Installing an internal microSD card
Procedure
1. Power down the server (Power down the server on page 38).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
106 Installing an internal microSD card
To Next Page
Loading...
