8. Install the primary PCIe riser cage (Installing the primary PCIe riser cage on page 45).
9. Install the access panel (Installing the access panel on page 41).
10. Install the server into the rack (Installing the server into the rack on page 34).
11. Connect each power cord to the server.
12. Connect each power cord to the power source.
13. Power up the server (Powering up the server on page 38).
Processor options
Identifying the processor type
The processor type installed in the server is briefly displayed during POST. To view this information and
additional processor specifications, do the following:
Procedure
1. Reboot the server.
The server restarts and the POST screen appears.
2. Press F9.
The System Utilities screen appears.
3. Select System Information | Processor Information.
The Processor Information screen shows detailed information about the processors installed in the server.
4. Press Esc until the main menu is displayed.
5. Select Reboot the System to exit the utility and resume the boot process.
80 Processor options
To Next Page
Loading...
