NOTE:
Your riser board might appear different.
10. Do one of the following:
• Install the primary PCIe riser cage (Installing the primary PCIe riser cage on page 45).
• Install the secondary PCIe riser cage (Installing the secondary PCIe riser cage on page 68).
11. Install the access panel (Installing the access panel on page 41).
12. Install the server into the rack (Installing the server into the rack on page 34).
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server (Powering up the server on page 38).
Installing a riser board into the tertiary PCIe riser cage
Prerequisites
Before installing this option, be sure that you have the following:
• T-10 Torx screwdriver
• The components included with the hardware option kit
Procedure
1. Power down the server (Power down the server on page 38).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 38).
• Remove the server from the rack (Removing the server from the rack on page 39).
4. Remove the access panel (Removing the access panel on page 40).
5. Remove the riser cage (Removing the PCIe riser cages on page 44).
6. Install the riser board.
74 Installing a riser board into the tertiary PCIe riser cage
To Next Page
Loading...
