Procedure
1. Power down the server (Power down the server on page 38).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Do one of the following:
• Extend the server from the rack (Extend the server from the rack on page 38).
• Remove the server from the rack (Removing the server from the rack on page 39).
4. Remove the access panel (Removing the access panel on page 40).
5. Remove the secondary riser cage blank.
6. When installing the secondary PCIe riser cage for the first time, remove the fastener from the riser cage.
7. Install the additional fastener supplied with the option kit onto the riser cage.
Installing hardware options 69
To Next Page
Loading...
