HP ProLiant DL585 - Locating and Removing the Torx T-15 Tool; Removing the Torx T-15 Tool

Removal and Replacement Procedures
Locating and Removing the Torx T-15 Tool
Many hardware procedures in the server are toolless, but a few require the removal of Torx
T-15 screws that have been installed for shipping or security reasons. A Torx T-15 tool ships
with the server for the removal of these screws.
1. Locate the Torx T-15 tool on the back of the server.
2. Slide the tool upward out of the retaining clips.
Figure 2-2: Removing the Torx T-15 tool
HP ProLiant DL585 Server Maintenance and Service Guide 2-5