12. Install the enablement board stabilizer.
13. If you intend to install an M.2 SSD on the enablement board, install it now
.
14. If you intend to install the serial port cable, install it now
.
15. If removed, install the air baffle
.
16. Install the access panel
.
17. Install the front bezel
.
18. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
19. Connect all peripheral cables to the server.
To Next Page
Loading...
