Installing the serial port cableInstalling the serial port cable
PrerequisitesPrerequisites
Before you perform this procedure, make sure that:
The M.2 SSD/dedicated iLO/serial port enablement board is installed .
5 mm hex nut screwdriver is available.
ProcedureProcedure
1. Power down the server
.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel
.
6. Remove the access panel
.
7. If installed, remove the air baffle
.
8. Remove the serial port blank.
9. Install the serial port.
To Next Page
Loading...
