11. If removed, install the air baffle
.
12. Install the access panel
.
13. Install the front bezel
.
14. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server
.
The installation is complete.
To configure the M.2 SSD, see the HPE Smart Array SR Gen10 Configuration Guide at the Hewlett Packard Enterprise websiteHewlett Packard Enterprise website
.
To Next Page
Loading...
