https://www.hpe.com/info/ilohttps://www.hpe.com/info/ilo
The iLO port is connected to a secure network.
b. Using a browser, navigate to the iLO web interface, and then log in.
Note the following:
The iLO hostname is on the serial number/iLO information pull tab.
If a DHCP server assigns the IP address, the IP address appears on the boot screen.
If a static IP address is assigned, use that IP address.
The default login credentials are on the serial label pull tab.
c. In the side navigation, click Remote Console & Media, and then launch a remote console.
Power on the Power on the serverserver
5. Press the Power On/Standby button.
For remote management, use the iLO virtual power button.
6. Using the SPP, update the following
:
System ROM
Storage controller
Network adapters
Intelligent Provisioning
Set up the storageSet up the storage
7. Set up the storage. Do one of the following:
To configure the server to boot from a SAN, see the following guide:
https://www.hpe.com/info/boot-from-san-config-guidehttps://www.hpe.com/info/boot-from-san-config-guide
If an HPE Smart Array SR controller is installed, use the HPE Smart Storage Administrator to create arrays:
a. From the boot screen, press F10 to run Intelligent Provisioning.
b. From Intelligent Provisioning, run HPE Smart Storage Administrator
.
If no controller option is installed, do one of the following:
AHCI is enabled by default. You can deploy an OS or virtualization software.
Disable AHCI, enable software RAID, and then create an array:
a. From the boot screen, press F9 to run UEFI System Utilities.
b. From the UEFI System Utilities screen, select System Configurations > BIOS/Platform Configuration (RBSU) > Storage
Options > SATA Controller Options > Embedded SATA Configuration > Smart Array SW RAID Support .
c. Enable Smart Array SW RAID Support .
d. Save the configuration and reboot the server.
e. Create an array:
i. From the boot screen, press F9 to run UEFI System Utilities.
ii. From the UEFI System Utilities screen, select System Configuration > Embedded Storage: HPE Smart Storage S100i
SR Gen10 > Array Configuration > Create Array.
Deploy an OS or virtualization softwareDeploy an OS or virtualization software
8. Deploy an OS or virtualization software. Do one of the following:
Use Intelligent Provisioning to deploy an OS. Press F10 at the POST screen.
Manually deploy an OS:
https://<iLO hostname or IP address>
To Next Page
Loading...
