b. Repeat step 12
to install a second hot-plug power supply in power supply bay 2.
14. If removed, install the air baffle
.
15. Install the access panel
.
16. Install the front bezel
.
17. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
18. Connect all peripheral cables to the server.
19. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
20. Power up the server
.
The installation is complete.
To Next Page
Loading...
