11. Install the non-hot-plug drive cage.
12. Connect the drive cables
.
13. If removed, install the air baffle
.
14. Install the access panel
.
15. Install the front bezel
.
16. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
17. Connect all peripheral cables to the server.
18. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
19. Power up the server
.
To Next Page
Loading...
