11. Connect the drive cables
.
12. If removed, install the air baffle
.
13. Install the access panel
.
14. Install the front bezel
.
15. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
16. Connect all peripheral cables to the server.
17. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
18. Power up the server
.
19. Perform the verification and configuration procedures required by the drive option.
For more information, see the documentation that ships with the drive option.
The installation is complete.
To Next Page
Loading...
