SubtopicsSubtopics
Installing a USB RDX docking stationInstalling a USB RDX docking station
Installing a USB RDX docking stationInstalling a USB RDX docking station
PrerequisitesPrerequisites
Make sure that the internal, lower USB port is available .
The LTO/RDX power extension cable (851615-B21) is required when installing a USB RDX docking station under the following
conditions:
The server is using a non-hot-plug power supply .
The server is using a Flexible Slot power supply and the USB RDX docking station is installed in the media bay 2.
Before you perform this procedure, make sure that you have a T-15 Torx screwdriver available.
About this taskAbout this task
Install an RDX docking station in either media bay 1 or 2.
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
CAUTION:CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated with
either a component or a blank.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode, place the server on a flat, level surface with the access panel facing up.
To Next Page
Loading...
