Hardware options installation 101
Cable routing to connect a SATA device
13. Install the access panel (on page 32).
14. Do one of the following:
o If the server is in a tower configuration, return the server to an upright position.
o If the server is in a rack configuration, slide the server into the rack.
15. Connect each power cord to the server.
16. Connect each power cord to the power source.
17. Power up the server (on page 29).
18. Do one of the following:
o For tower models, install the tower bezel (on page 31).
o For rack models, install the security bezel ("Security bezel option" on page 48).
GPU power cable option
For more information about product features, specifications, options, configurations, and compatibility, see
the product QuickSpecs on the HP website (http://www.hp.com/go/qs).
To install a third 150W GPU, a third power supply must be installed.
The server supports up to four graphic cards, install graphic card options in PCIe slots 1, 3, 6, or 8.
IMPORTANT: If installing a graphic card for the first time, we highly recommend that you contact
HP Technology Services for assistance.
To install the component:
1. Do one of the following:
o For tower models, open and remove the tower bezel ("Remove the tower bezel" on page 30).
o For rack models, if installed, remove the security bezel ("Remove the security bezel (optional)" on
page 30).
2. Power down the server (on page 29).
To Next Page
Loading...
