HP T3500

●
The borders of colored blocks are wrongly colored.
To correct this kind of problem:
1. Align the printhead. See Align the printhead on page 240.
2. Reseat the printhead by removing and then reinserting it. See Remove the printhead on page 149 and
Insert the printhead on page 153.
Lines are discontinuous
If your lines are broken in the following way:
1. Check that you are using appropriate print-quality settings. See Printing on page 71.
2. When printing on uncoated paper in Fast mode, try loading the paper as Bright Bond.
3. Align the printhead. See Align the printhead on page 240.
4. Reseat the printhead by removing and then reinserting it. See Remove the printhead on page 149 and
Insert the printhead on page 153.
ENWW
Lines are discontinuous 197