●
The Similar to comparison, ~=, permits searching for attribute values that are similar to
the search value.
●
Finally, the Not Equals comparison, !=, permits searching for attribute values that are
not equivalent to the search value.
4. Finally, press the Search button. Results will appear in the Search tree to the left. See the
procedure To browse for a User or Group earlier in this section for more information about
browsing the search results.
5.
Adding a User or Group to be Imported:
1. Locate the User or Group, either by Browse or Search.
2. Add the User or Group by either:
●
Double-clicking the User or Group.
OR
●
Click the User or Group and click the Add button near the bottom left of the dialog box.
3. The User/Group should now be on the right side.
NOTE: The Users and Groups are not imported until the Import Button in the bottom right is clicked.
Be sure to click the Import button when you are finished importing Users and Groups.
Removing a User or Group from being Imported:
1. Select a User or Group on the right side of the Import Users and Groups dialog box.
2. Click the Remove button.
Examining a User or Group:
1. Click a User or Group.
User Management 173
To Next Page
Loading...
Need help?
General