Setup procedure
1. The HP Z1 G2 Workstation weighs 19.2 kg (42.3 lbs) for the non-touch model and 21.0 kg (46.3 lbs) for
the touch model, and must be removed from the box by two people.
WARNING! If a product is shipped in packaging marked with this icon
, the product must always be
lifted by two people to avoid personal injury due to product weight.
WARNING! To reduce the risk of electric shock or damage to your equipment:
●
Plug the power cord into an AC outlet that is easily accessible at all times.
●
Disconnect power from the workstation by unplugging the power cord from the AC outlet (not by
unplugging the power cord from the workstation).
●
If your power cord has a 3-pin attachment plug, plug the cord into a grounded (earthed) 3-pin
outlet. Do not disable the power cord grounding pin, for example, by attaching a 2-pin adapter.
The grounding pin is an important safety feature.
For more safety and regulatory information, refer to the Regulatory, Safety and Environmental Notices
located with the user guide on your workstation.
2. Push the unit down to its lowest horizontal position.
CAUTION: Never open the unit unless it is in the lowest horizontal position. Otherwise, system
components may be damaged.
3. Slide the latches on the bottom of the workstation outward and open the chassis.
Setting up the workstation 11
To Next Page
Loading...
Need help?
General
