HPE FlexNetwork 5130 Series User Manual

10
Solution
Choose a solution depending on the module that uses the ACL.
ACL used in a QoS policy
To resolve the problem when the ACL is used in a QoS policy:
1. Verify that the QoS policy is configured correctly:
a. Use one of the following commands to check the QoS policy for configuration errors,
depending on the policy application destination:
Destination Command
Interface
display qos policy interface
VLAN
display qos vlan-policy
Global
display qos policy global
Control plane
display qos policy control-plane slot
slot-number
b. If the QoS policy does not contain a class-behavior association, associate the traffic
behavior with the traffic class.
c. If the QoS policy contains a class-behavior association, execute the display traffic
classifier user-defined command and the display traffic behavior user-defined
command to check for traffic class and behavior configuration errors, respectively.
− If they are configured incorrectly, reconfigure them.
− If they are configured correctly, go to step 2.
2. Verify that th
e ACL is configured correctly.
Execute the display acl command to check whether the ACL is configured correctly.
{ If the ACL is configured incorrectly, reconfigure it.
{ If the ACL is configured correctly, go to step 3.
3. If the problem persists, contact Hewlett Packard Enterprise Support.
ACL used in a packet filter
To resolve the problem when the ACL is used in a packet filter:
1. Verify that the packet filter is configured correctly.
Execute the display packet-filter command to check whether the packet filter is configured
correctly.
{ If there are any configuration errors, reconfigure the packet filter.
{ If there is no configuration error, go to step 2.
2. Verify that the ACL is configured correctly.
Execute the display acl command to check whether the ACL is configured correctly.
{ If the ACL is configured incorrectly, reconfigure it.
{ If the ACL is configured correctly, go to step 3.
3. If the problem persists, contact Hewlett Packard Enterprise Support.
Related commands
This section lists the commands that you might use for troubleshooting ACLs.

HPE FlexNetwork 5130 Series Specifications

General

Category	Network Switch
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x SFP+ ports
Routing Protocol	Static routing, RIP, OSPF, BGP
PoE	Available on some models (PoE+)
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4094
Operating Humidity	5% to 95% (noncondensing)