HPE FlexNetwork 5130 Series User Manual

26
suppression, multicast suppression, and unknown unicast suppression. To adjust the
suppression thresholds, execute the broadcast-suppression, multicast-suppression,
and unicast-suppression commands.
5. Verify that no congestion occurs by using the display qos queue interface command.
If congestion occurs, locate and resolve the problem by referencing related congestion
management documents.
6. If the problem persists, contact Hewlett Packard Enterprise Support.
Related commands
This section lists the commands that you might use for troubleshooting Layer 2 forwarding failure.
Command Description
display dot1x
Displays session information, statistics, and
configurations about 802.1X.
display interface
Displays Ethernet interface information.
display ip source binding
Displays IPv4 source guard binding entries.
display ipv6 source binding
Displays IPv6 source guard binding entries.
display link-aggregation verbose
Displays detailed information about the
aggregation groups that correspond to the
aggregate interfaces.
display mac-address blackhole
Displays blackhole MAC address entries.
display mac-forced-forwarding vlan
Displays MFF information for a VLAN.
display packet-filter
Displays whether an ACL has been successfully
applied to an interface for packet filtering.
display portal interface
Displays the portal configuration information.
display qos lr interface
Displays the rate limit configuration and statistics
on a specified interface or all the interfaces.
display qos policy
Displays user-defined QoS policy configuration
information.
display qos policy global
Displays information about global QoS policies.
display qos policy interface
Displays information about the QoS policies
applied to an interface or all interfaces.
display qos queue interface
Displays traffic statistics collected for an interface
on a per-queue basis.
display qos vlan-policy
Displays information about QoS policies applied to
VLANs.
display smart-link group
Displays smart link group information.
display this
Displays the running configuration in the current
view.

HPE FlexNetwork 5130 Series Specifications

General

Category	Network Switch
Ports	24 or 48 10/100/1000 ports
Uplink Ports	4 x SFP+ ports
Routing Protocol	Static routing, RIP, OSPF, BGP
PoE	Available on some models (PoE+)
Input Voltage	100-240 VAC
Operating Temperature	0°C to 45°C
Management	Web, CLI, SNMP
Jumbo Frame Support	Yes
VLANs	4094
Operating Humidity	5% to 95% (noncondensing)