12. Connect the optical drive cable .
13. Install the middle cover .
14. Install the access panel .
15. Install the server into the rack.
16. Connect all peripheral cables to the server.
17. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
18. Power up the server.
19. Install the front bezel .
ResultsResults
The installation is complete.
Installing the optical drive in the SFF drive chassisInstalling the optical drive in the SFF drive chassis
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have the following items available:
Optical drive cage assembly (P56654-B21)
T-10 Torx screwdriver
Phillips No. 1 screwdriver
Spudger or any small prying tool
About this taskAbout this task
To Next Page
Loading...
