b. Simultaneously push and rotate the half-turn spring latch to 180° (callout 2).
c. Close the spring latch (callout 3).
12. Connect all necessary internal cabling to the expansion card.
For more information on these cabling requirements, see the documentation that ships with the option.
13. Install the access panel .
14. Install the server into the rack.
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server.
ResultsResults
The installation is complete.
Storage controller optionsStorage controller options
This server has no embedded software RAID support. Direct attached SATA drives operate AHCI mode.
To support hardware RAID, install a storage controller option:
HPE MR type-o and type-p Gen11 controllers
HPE SR type-p Gen11 controllers
HPE SR type-p Gen10 Plus controllers
When a tri-mode storage controller option is used together with a U.3 drive backplane, the system will support mixed drive configuration.
To Next Page
Loading...
