2. Remove the dust plug or protective cover from the transceiver.
3. Connect a compatible LAN segment cable to the transceiver.
4. Make sure that the NIC link LED on the port is solid green.
For more information on the port LED behavior, see the documentation that ships with the transceiver.
5. If needed, see the transceiver documentation for the model-specific fastening mechanism applicable to the transceiver.
ResultsResults
The installation is complete.
Drive optionsDrive options
Depending on the drive backplane installed, the server supports the following drive types:
Hot-plug LFF SAS or SATA drives
Hot-plug SFF SAS, SATA, or U.3 NVMe drives
Hot-plug E3.S PCIe5 NVMe SSDs
This server has no embedded software RAID support. Direct attached SATA or NVMe drives operate in AHCI mode.
To support hardware RAID, install a storage controller option .
SubtopicsSubtopics
Drive installation guidelinesDrive installation guidelines
Installing a hot-plug SAS, SATA or NVMe driveInstalling a hot-plug SAS, SATA or NVMe drive
Installing an E3.S driveInstalling an E3.S drive
Drive installation guidelinesDrive installation guidelines
Observe the following general guidelines:
The system automatically sets all drive numbers.
To Next Page
Loading...
