HPE ProLiant DL325 Gen11 - Connecting a DC Power Cable to a DC Power Source

9. Immediately slide the power supply into the bay until it clicks into place.
10. Make sure the -48 V DC power source is off or the PDU breaker is in the off position, and then connect the power cord to the -48 V DC
power source or PDU.
11. Turn on the -48 V power source or switch the PDU breaker to the on position to supply -48 V to the power supply.
12. Connect a DC power cable to a DC power source .
13. Make sure that the power supply LED is green.
ResultsResults
The installation is complete.
Connecting a DC power cable to a DC power sourceConnecting a DC power cable to a DC power source
About this taskAbout this task
HPE ProLiant DL325 Gen11 Server User Guide 90