Install the access panelInstall the access panel
Install the server into the rackInstall the server into the rack
Power up the serverPower up the server
Remove the front bezelRemove the front bezel
About this taskAbout this task
If you are using the iLO virtual power button to power the server on/off, you do not need to remove the front bezel. Remove the front bezel
only if you need to access the front panel components.
ProcedureProcedure
1. If installed, remove the Kensington security lock.
For more information, see the lock documentation.
2. Press the bezel release latch, and then pivot the bezel open.
3. Release the right side of the bezel from the front panel.
To Next Page
Loading...
