finger or other conductor may damage system boards or other static-sensitive devices. This type of damage may reduce the life expectancy
of the system or component.
To prevent electrostatic damage:
Avoid hand contact by transporting and storing products in static-safe containers.
Keep electrostatic-sensitive parts in their containers until they arrive at static-free workstations.
Place parts on a grounded surface before removing them from their containers.
Avoid touching pins, leads, or circuitry.
Always be properly grounded when touching a static-sensitive component or assembly. Use one or more of the following methods when
handling or installing electrostatic-sensitive parts:
Use a wrist strap connected by a ground cord to a grounded workstation or computer chassis. Wrist straps are flexible straps with a
minimum of 1 megohm ±10 percent resistance in the ground cords. To provide proper ground, wear the strap snug against the skin.
Use heel straps, toe straps, or boot straps at standing workstations. Wear the straps on both feet when standing on conductive
floors or dissipating floor mats.
Use conductive field service tools.
Use a portable field service kit with a folding static-dissipating work mat.
If you do not have any of the suggested equipment for proper grounding, have an authorized reseller install the part.
For more information on static electricity or assistance with product installation, contact an authorized reseller.
OperationsOperations
This chapter describes the hardware operations carried out prior to and after installing or removing a hardware component, or performing a
server maintenance or troubleshooting procedure. Before performing these hardware operations, review the:
Rack warnings and cautions
Server warnings and cautions
SubtopicsSubtopics
Remove the front bezelRemove the front bezel
Power down the serverPower down the server
Extend the server out of the rackExtend the server out of the rack
Remove the server from the rackRemove the server from the rack
Remove the access panelRemove the access panel
Remove the middle coverRemove the middle cover
Remove the air baffleRemove the air baffle
Remove the fanRemove the fan
Remove the primary riser cageRemove the primary riser cage
Install the primary riser cageInstall the primary riser cage
Install the air baffleInstall the air baffle
Install the middle coverInstall the middle cover
To Next Page
Loading...
