11. Connect all necessary internal cabling to the expansion card.
For more information on these cabling requirements, see the documentation that ships with the option.
12. Install the riser cage.
13. Install the access panel .
14. Install the server into the rack.
15. Connect all peripheral cables to the server.
16. Connect the power cords:
a. Connect each power cord to the server.
b. Connect each power cord to the power source.
17. Power up the server.
ResultsResults
The installation is complete.
Installing an expansion card in the NS204i-u + secondary low-profile riser cageInstalling an expansion card in the NS204i-u + secondary low-profile riser cage
PrerequisitesPrerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
About this taskAbout this task
CAUTION:CAUTION: A discharge of static electricity from a finger or other conductor might damage system boards or other static-
sensitive devices. To prevent damage, observe antistatic precautions.
ProcedureProcedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
