6. Power up the server.
Removing a hot-plug SAS/SATA/NVMe driveRemoving a hot-plug SAS/SATA/NVMe drive
CAUTION:CAUTION: For proper cooling, do not operate the server without the access panel, baffles, expansion slot covers, or
blanks installed. If the server supports hot-plug components, minimize the amount of time the access panel is open.
1. Determine the status of the drive from the hot-plug drive LED definitions.
2. Back up all server data on the drive.
3. Remove the drive.
Figure 1. Figure 1. SFF driveSFF drive
Figure 2. Figure 2. LFF driveLFF drive
Accessing the Systems Insight DisplayAccessing the Systems Insight Display
About this taskAbout this task
The Systems Insight Display is only available on SFF platforms.
ProcedureProcedure
1. Press and release the panel.
To Next Page
Loading...
