11. Install the access panel .
12. Slide the server into the rack.
13. Connect each power cord to the server.
14. Connect each power cord to the power source.
15. Power up the server .
ResultsResults
The installation is complete.
Installing the serial port optionInstalling the serial port option
PrerequisitesPrerequisites
Before installing this option, be sure you have the following:
The components included with the hardware option kit
5 mm nut driver
ProcedureProcedure
1. Observe the following alerts:
WARNING:WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:CAUTION: To prevent damage to electrical components, properly ground the server before beginning any
installation procedure. Improper grounding can cause electrostatic discharge.
2. Back up all server data.
3. Power down the server.
4. Remove all power:
a. Disconnect each power cord from the power source.
To Next Page
Loading...
