8. Install the access panel .
9. Install the server in the rack.
10. Connect each power cord to the server.
11. Connect each power cord to the power source.
12. Power up the server.
ResultsResults
The installation is complete.
Installing the 4LFF optical driveInstalling the 4LFF optical drive
PrerequisitesPrerequisites
Before installing this option, be sure that you have the following:
The components included with the hardware option kit
T-10 Torx screwdriver
LFF optical cable option kit
An optical drive
ProcedureProcedure
1. Back up all server data.
2. Power down the server .
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Do one of the following:
a. Extend the server from the rack .
b. Remove the server from the rack .
5. Remove the LFF optical drive bay blank.
To Next Page
Loading...
