7. Set the anti-tilt wires to the unlocked position.
8. CAUTION:CAUTION:
To prevent mechanical damage or depositing oil on your hands or other contaminant to the heatsink contact
surface, hold the heatsink only by the edge of its base plate. Do not touch the heatsink fins.
Install the processor-heatsink module:
a. When using a torque wrench to tighten the heatsink screws, set it to 0.9 N-m (8 in-lb) of torque .
b. Note the Front of serverFront of server text on the heatsink label to correctly orient the processor-heatsink module over the bolster plate.
c. Carefully lower the processor-heatsink module onto the bolster plate guide posts.
The posts are keyed so that the module can only be installed one way. Make sure that the module is properly seated on the
bolster plate before securing the screws.
To Next Page
Loading...
