a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
5. Do one of the following:
a. Extend the server from the rack on page 31.
b. Remove the server from the rack on page 32.
6. Remove the access panel on page 32.
7. Remove the primary PCI riser cage (Remove the primary PCI riser cage on page 34).
8. Remove the slot 2 expansion board blank.
9.
Use a Torx T-10 screwdriver to install the controller.
The controller can also be installed in slot 1.
Hardware options installation 105
To Next Page
Loading...
