HPE ProLiant MicroServer Gen10 Plus v2 - Trusted Platform Module

To Next Page

To Previous Page

ItemItem DescriptionDescription Supported optionSupported option

1 iLO dedicated network module slot Install the iLO enablement option here.

2 PCIe4 x16 expansion slot Install a half-height, half-length (low-profile) PCIe4 expansion card here.

For list of supported expansion options, see the product QuickSpecs on the

server website at https://www.hpe.com/servers/microserver-gen10-plus-v2https://www.hpe.com/servers/microserver-gen10-plus-v2.

Trusted Platform Module 2.0Trusted Platform Module 2.0

The Trusted Platform Module 2.0 (TPM) is a hardware-based system security feature that securely store artifacts used to authenticate the

platform. These artifacts can include passwords, certificates, and encryption keys.

The TPM 2.0 is embedded on the server system board.

The TPM 2.0 is supported with specific operating system support such as Microsoft Windows Server 2012 R2 and later. For more

information about operating system support, see the product QuickSpecs on the Hewlett Packard Enterprise website

(https://www.hpe.com/info/qshttps://www.hpe.com/info/qs). For more information about Microsoft Windows BitLocker Drive Encryption feature, see the Microsoft

website (https://www.microsoft.comhttps://www.microsoft.com).

SubtopicsSubtopics

Trusted Platform Module 2.0 guidelinesTrusted Platform Module 2.0 guidelines

BitLocker recovery key/password retention guidelinesBitLocker recovery key/password retention guidelines

Trusted Platform Module 2.0Trusted Platform Module 2.0 guidelines guidelines

CAUTION:CAUTION:

Always observe the TPM guidelines in this section. Failure to follow these guidelines can cause hardware damage or

halt data access.

If you do not follow procedures for modifying the server and suspending or disabling the TPM in the OS, an OS that is

using TPM might lock all data access. This includes updating system or option firmware, replacing hardware such as the

system board and drives, and modifying TPM OS settings.

Changing the TPM mode after installing an OS might cause problems, including loss of data.

Hewlett Packard EnterpriseHewlett Packard Enterprise SPECIAL REMINDER: SPECIAL REMINDER: Before enabling TPM functionality on this system, you must ensure that your intended use

of TPM complies with relevant local laws, regulations and policies, and approvals or licenses must be obtained if applicable.

When the embedded TPM is enabled:

In UEFI boot mode, the Trusted Platform Module operates in TPM 2.0 mode.

In legacy boot mode, the Trusted Platform Module operation is not supported.