The server supports onboard SATA controller cabling. Use the table and image below to cable your server for onboard SATA mode.
IMPORTANT:IMPORTANT:
The four-bay non-hot-plug drive cable assembly consists of the drive and ambient temperature sensor cables. If any of
these cables becomes defective, the entire cable assembly will need to be replaced.
ColorColor DescriptionDescription
Orange Drive power cable
Blue Drive sideband signal cable
Gold Drive data cable
Pink Ambient temperature sensor cable
Four-bay drive cabling: Type-p controller cablingFour-bay drive cabling: Type-p controller cabling
IMPORTANT:IMPORTANT:
The four-bay non-hot-plug drive cable assembly consists of the drive and ambient temperature sensor cables. If any of
these cables becomes defective, the entire cable assembly will need to be replaced.
To Next Page
Loading...
