HPE ProLiant ML110 Gen10

Installing an internal USB device
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
• Server in rack mode: Remove the server from the rack.
• Server in tower mode:
Position the tower server for hardware configuration.
5. Remove the access panel.
6.
Remove the PCI air bale.
7.
Remove the system air bale.
8.
Locate the internal USB connector.
9.
Plug in the USB device into the internal USB port.
10. Install the system air bale.
11.
Install the PCI air bale.
12. Install the access panel.
13. Do one of the following:
Hardware options installation
103