14. Install the system air baîš‚le.
15.
Install the PCI air baîš‚le.
16.
Install the access panel.
17.
Do one of the following:
• Server in rack mode:
Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
18.
Connect all peripheral cables to the server.
19.
Connect each power cord to the server.
20.
Connect each power cord to the power source.
21.
Power up the server.
The installation is complete.
Installing the HPE NS204i-p NVMe OS Boot Device option
Prerequisites
Before beginning installation, ensure that the server is updated with the latest operating system firmware and drivers.
Procedure
Installing drives onto the boot device
1. Remove the liner from the thermal interface pad.
Hardware options installation
87
To Next Page
Loading...
