HPE ProLiant ML110 Gen10

2. Install the front bezel.
3.
Install the access panel.
4.
Do one of the following:
• Server in rack mode: Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
5.
Connect all peripheral cables to the server.
6.
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.
Power up the server.
Remove the system air bale
Procedure
1.
Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
• Server in rack mode:
Remove the server from the rack.
• Server in tower mode:
Position the tower server for hardware configuration.
Operations
32