HPE ProLiant ML110 Gen10

2. Do one of the following:
• Lock the internal locker.
• Leave the internal locker in unlock position if you want to access the front panel any time without removing the
access panel.
3.
Install the access panel.
4.
Do one of the following:
• Server in rack mode:
Install the server into the rack.
• Server in tower mode: Return the server to an upright position.
5.
Connect all peripheral cables to the server.
6.
Connect each power cord to the server.
7.
Connect each power cord to the power source.
8.
Power up the server.
Remove the PCI air bale
Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
Operations
30