HPE ProLiant ML110 Gen10

• Server in rack mode: Remove the server from the rack.
• Server in tower mode: Position the tower server for hardware configuration.
5. Remove the access panel.
6. Remove the PCI air bale.
7. Remove the system air bale.
8. Disconnect all the power supply cables connected to the system board.
9. Remove the existing power supply.
10.
Install the ATX 550W non-hot-plug power supply.
11. Connect the power supply cables.
12. Install the system air bale.
13.
Install the PCI air bale.
Hardware options installation
60