5. Disconnect all peripheral cables from the server.
6. Do one of the following:
• Server in tower mode: Position the tower server for hardware configuration on page 40.
• Server in rack mode: Extend the server from the rack on page 41.
7. Remove the access panel on page 45.
8. Remove the air baffle on page 46.
9. If installed, remove the fan cage.
10. Remove the non-hot-plug drive cage:
a. Disconnect the SATA-power split cables from the drives.
b. Remove the drive cage.
11. Remove the drive.
50 Removal and replacement procedures
To Next Page
Loading...
