13. Install the dedicated iLO management port card.
14. If removed from slot 10, install the expansion board.
15. Connect any required cables.
16. Install the drive cage assembly.
17. Connect all cables to the drive backplane.
18. Install the air baffle.
If the 4:1 riser signal cable or Smart Storage Battery are installed in the air baffle, reconnect the cables to
the risers. For more information, see "Installing the air baffle."
19. Install the access panel.
20. Install the server into the chassis.
21. Connect all peripheral cables to the server .
22. Power up the server .
106 Hardware options installation
To Next Page
Loading...
