www.hpe.com/support/StoreOnceQuickSpecs. Click Search Active QuickSpecs. In the Search box,
enter "D3000 enclosures" (for StoreOnce models 3640 and 5200) or "D6020 enclosure" (for StoreOnce
models 5250 and 5650), select Search only in title, then click Go.
Always refer to the rack documentation and the safety guide at www.hpe.com/support/Safety-
Compliance-EnterpriseProducts for detailed safety information.
Rack warnings
For detailed safety information, refer to the rack documentation and the Safety Guide provided with the
rack product.
WARNING: To reduce the risk of personal injury or damage to the equipment, be sure that:
• The leveling jacks are extended to the floor.
• The full weight of the rack rests on the leveling jacks.
• The stabilizing feet are attached to the rack of a single-rack installation.
• Only one component is extended at a time. A rack may become unstable if more than one
component is extended for any reason.
CAUTION: Use extreme caution when installing and pulling units from the rack. They can slip and
fall, damaging the StoreOnce System or causing personal injury.
HPE is not responsible for any injury or damage caused by the mishandling of the StoreOnce
System. Always use at least two people to lift and install an enclosure into the rack.
Space requirements
Sufficient space is required to the front and to the right-hand side of the rack to ensure that there is
enough clearance to maneuver the disks in and out of drawer 2.
• To the front — approximately 43 inches (1080 mm) from the inside of the front rack column.
• To the right — at least 12 inches (300 mm),
100 Installing capacity upgrade kits
To Next Page
Loading...
