HPE StoreOnce 3620

The Integrated Lights Out (iLO) Configuration screen shows the HPE Integrated Lights Out
network configuration.
• In environments that do not use DHCP, DNS, or WINS, configure a static IP address during
bootup.
a. Restart or power on the StoreOnce Server.
b. Press F9 in the server POST screen.
The UEFI System Utilities start.
c. Navigate to System Configuration > iLO 5 Configuration > Network Options.
d. Configure the iLO network options and note the iLO IP address, iLO subnet mask, and iLO
gateway.
Verifying the hardware installation
The StoreOnce System is supplied preconfigured according to the options specified at the time of order.
Any additional storage and/or Optional Hardware PCIe cards are already installed, licensed, and available
for use.
When configuring a system that someone else installed, verify the hardware installation before continuing
the system configuration.
Prerequisites
• The system hardware was installed using the instructions in the start here guide or this document.
• The First Time Setup setup Wizard was run.
Open a web browser and access the StoreOnce system. The First Time Setup wizard is automatically
displayed. Use the First Time Setup wizard to configure the system for use.
Procedure
1. Verify that any optional Ethernet or Fibre Channel cards that were not included in the original order are
installed.
For instructions, see Installing optional hardware. You can install the license during the configuration
process.
2. Verify that all network cables are connected.
3. If the system has optional FC cards, verify that all FC cables are connected.
4. If the system has one or more storage enclosures, verify that all power cables to the storage
enclosures are installed.
5. If the system has storage enclosures, verify that all enclosures are properly labeled, and all SAS
cables are properly labeled and installed.
6. If the system is using a network management application, verify that an Ethernet cable is installed in
the iLO port.
124 Configuring a newly installed system