HPE StoreOnce 3620

HPE StoreOnce 3620 System handling requirements
Component Rack space Weight
System server 2U 25 kg (55 lbs)
Capacity upgrade kit N/A 4.5 kg (10 lbs)
CAUTION: Use extreme care when installing and pulling units from the rack. Unattached units can
slip and fall, damaging the StoreOnce System or causing personal injury.
• Always use at least two people to lift and locate the server or enclosure into the rack.
• Hewlett Packard Enterprise is not responsible for any damage or injury caused by mishandling
the StoreOnce System.
TIP: Hard disks are preconfigured and must remain installed or returned to the same disk slots they
arrived in.
You can remove the hard disks to make the enclosures lighter and easier to install. All hard disks
must be returned to their original slots before the system is powered on. Failure to return each disk
to its proper location will result in the system failing to start.
Label the disks with the provided label kits before removing them from the enclosure for ease of
installation and maintenance.
Installing the StoreOnce 3620 System
Prerequisites
Required tools:
• Torx T25 screwdriver
• A monitor and USB keyboard or a KVM for initial network configuration
Procedure
1. Verify that you received the following components:
• StoreOnce System server
• Rail kit
• Security bezel
• Two power cables
• Two network cables
2. Record the iLO default network information from the label on top of the server.
iLO user name:________________________
iLO network name:_____________________
iLO password:_________________________
3. Install the optional PCIe cards, if necessary.
HPE StoreOnce 3620 System 9