HPE StoreOnce 3620

9. Configure the basic network.
By default, the system will have already attempted to obtain a DHCP address on LAN port 1. If you
already know the IP address that was assigned over DHCP, this step is optional.
a. Log in using the default user name and password.
Default user name: console
Default password: changeme
b. Change the console password to proceed.
Choose a secure password with at least eight characters that is memorable to you.
c. To configure a static address for LAN port 1 (eno1), select the Configure initial network
option from the console menu.
If the system obtained an IP address through DHCP, it is displayed. Note the DHCP assigned IP
address or the static address details.
IP address:______________________________
Prefix length:_____________________________
Gateway:________________________________
DNS:________________________________
You can remove the console display and keyboard.
10. Open a web browser and use the IP address from the previous step to access the StoreOnce
system.
The First Time Setup wizard is automatically displayed. Use the First Time Setup wizard to configure
the system for use.
The setup steps include:
• Setting the Administrator Password.
• Setting the Console Password.
• Setting basic System Information such as the system name (host name), location, and contact
information.
• Setting the System Date & Time. You can set the date and time manually, or synchronize the
date and time with a network time server.
• Configuring Storage. The wizard detects the factory installed storage. The wizard also enables
you to configure additional storage capacity that you might have installed. The wizard also reports
issues with additional storage, for example, when additional storage is not installed in the correct
location.
• Configuring Remote Support.
Configuring a newly installed StoreOnce 3620 system
For additional information and instructions on each step, see the online help or user guide.
HPE StoreOnce 3620 System 13