Figure 9: HPE StoreOnce 3640 System rack layout
Item Description
1 Server node.
2 JBOD 1: First capacity upgrade kit. Install under the server.
3 JBOD 2: Second capacity upgrade kit. Install under JBOD 1.
2. Install two power cords for the server and two power cords for each capacity upgrade enclosure.
HPE StoreOnce 3640 System handling requirements
Component Rack space Weight
System server 2U 29 kg (64 lbs)
Capacity upgrade enclosure 2U 26.2 kg (58 lbs)
CAUTION: Use extreme care when installing and pulling units from the rack. Unattached units can
slip and fall, damaging the StoreOnce System or causing personal injury.
• Always use at least two people to lift and locate the server or enclosure into the rack.
• Hewlett Packard Enterprise is not responsible for any damage or injury caused by mishandling
the StoreOnce System.
TIP: Hard disks are preconfigured and must remain installed or returned to the same disk slots they
arrived in.
You can remove the hard disks to make the enclosures lighter and easier to install. All hard disks
must be returned to their original slots before the system is powered on. Failure to return each disk
to its proper location will result in the system failing to start.
Label the disks with the provided label kits before removing them from the enclosure for ease of
installation and maintenance.
HPE StoreOnce 3640 System 21
To Next Page
Loading...
