HPE StoreOnce 3620

HPE StoreOnce 5250 and 5650 Systems handling
requirements
Component Rack space Weight
System server 2U 29 kg (64 lbs)
Capacity upgrade kit (disk pack) N/A 11.4 kg (25.1 lbs)
Drawer upgrade enclosure 5U 31.1 kg (66 lbs)
CAUTION: Use extreme caution when installing and pulling units from the rack. Unattached units
can slip and fall, damaging the StoreOnce System or causing personal injury. Hewlett Packard
Enterprise is not responsible for any damage or injury caused by mishandling the StoreOnce
system.
Always use at least two people to lift and locate an enclosure into the rack.
TIP: Hard disks are preconfigured and must remain installed or returned to the same disk slots they
arrived in.
You can remove the hard disks to make the enclosures lighter and easier to install. All hard disks
must be returned to their original slots before the system is powered on. Failure to return each disk
to its proper location will result in the system failing to start.
Label the disks with the provided label kits before removing them from the enclosure for ease of
installation and maintenance.
Installing the StoreOnce 5250 and 5650 base systems
WARNING: When placing the enclosure into a rack, to reduce the risk of personal injury or damage
to equipment:
• Extend the rack leveling jacks to the floor.
• Ensure that the full weight of the rack rests on the leveling jacks.
• Install the rack stabilizer kit on the rack.
WARNING: A fully loaded enclosure weighs 88.2 kg (194 lbs). Always use enough people or other
support to lift an enclosure into the rack. When loading an enclosure into the rack above chest level,
an additional person is required to assist with aligning the enclosure with the rails.
Prerequisites
Required tools:
• Torx T25 screwdriver
• A monitor and USB keyboard or a KVM for initial network configuration
Procedure
1. Verify that you received the server components.
HPE StoreOnce 5250 and 5650 Systems 57