Completing the PCIe card installation
Procedure
1. Reconnect the cables from the storage controller card and expander cards.
2. Replace the PCIe riser cage.
3. Replace the access panel.
a. Place the access panel on top of the server with the latch open.
Allow the panel to extend past the rear of the server approximately 1.25 cm (0.5 in).
b. Push down on the latch.
The access panel slides to a closed position.
c. Tighten the security screw on the latch.
4. Slide the server back into the rack and secure it.
WARNING: To reduce the risk of personal injury, be careful when pressing the server rail-release
latches and sliding the server into the rack. The sliding rails could pinch your fingers.
5. Reconnect the external SAS cables.
6. Power on the StoreOnce System manually, or by using the iLO interface.
Installing SFP transceivers, if necessary, and connecting to the network or
SAN
Procedure
1. Install SFP transceivers as follows:
a. 10/25Gb SFP Network card:
• For 10GbE connectivity, use the supplied optical 10 Gb SR SFP+ transceivers (Part Number:
455884-B21).
• For 25GbE connectivity, 25 Gb SFP+ transceivers (Part Number: 845398-B21) must be
purchased separately.
138 Installing optional hardware
To Next Page
Loading...
