HPE StoreOnce 3620

Procedure
1. Remove the front bezel from the StoreOnce System.
Remove the locking device to unlock the security bezel. Pull the bezel out and away from the front of
the appliance.
Figure 3: Removing the locking device
2
3
1
Figure 4: Removing the front bezel
2. Remove the blanking plates from the right six disk bays numbered 3, 4, 7, 8, 11, and 12. Push in the
latch (1) until it releases and pull out the plate (2).
NOTE: All six disks must be installed before you can expand storage.
HPE StoreOnce 3620 System 17